Helunsi 2 Pcs Inline Switch, Cord Appliance Black Switch, Button ON OFF for Lamp, Rated 10A 250V, Replacement Repair Control LED Electrical Extension Cable Wire Plug Light Wiring - With Indicator Neon

Heaterhttps://www.amazon.com/dp/B07573FKSG Replacement thermostat*Only if you find you need it (see below)https://www.digikey.com/en/products/detail/cantherm/A1014005/5287293?so=98295643 Temperature Controller:I use Inkbirds, when on sale they're around $25 for the non-wifi model. There are a lot of different options available, many cheaper.https://www.amazon.com/dp/B01HXM5UAC Inline power switch:I cut the heater's power cord and wire one of these in. This lets me just set the Inkbird to 60c, hide it and never think about it again.https://www.amazon.com/Inline-Switch-Appliance-Button-Indicator/dp/B0CPPGBDRS/ I use this mount on Makerworld for my P1 units, I have a model I've designed for my Snapmaker U1s that I haven't posted yet, it needs a minor modification. *The thermostat that's included with the heater trips at around 60c, and can take awhile to reset and start heating again. If this winds up being a problem (temps drop too much), you can either replace it with a bit of copper wire (don't do that) or buy a cheap replacement with a higher temperature limit for a couple of bucks. Pop off the fan cover, unscrew the old one, and screw the new one in. Super easy.