TIMKEN 6002-2RS 4PACK Double Rubber Seal Bearings 15x32x9mm, Pre-Lubricated and Stable Performance and Cost Effective, Deep Groove Ball Bearings

https://www.amazon.com/dp/B088NGT5GK?ref=ppx_yo2ov_dt_b_fed_asin_title And the extra protection bushings: https://www.amazon.com/dp/B0FLZ6N55D?ref=ppx_yo2ov_dt_b_fed_asin_title Also order a circlip plier set if you don't have any on hand, plenty to choose from on Amazon

Timken Bearings link: https://www.amazon.com/dp/B088NGT5GK?ref=ppx_yo2ov_dt_b_fed_asin_title

https://a.co/d/07khbQxx

The bearings on the blade motors. 2 on each motor and this is a 4 pack so works out pretty well. https://a.co/d/07khbQxx Sorry I didnt take alot of photos or make a how to. Once I started I just got focused on the job and forgot. If the originals were sealed they were terribly sealed. Seen alot of posts about exposed bearings and seals falling off. Also I sprayed the underside of the deck off with a hose before I started taking it apart and I did see a small amount of water inside the motor stator. The only path I could see was up the shaft where the old bearing was. Just be sure to get everything clean and the new ones pop right in and everything slides back on the shaft easily. Some fine grit sandpaper or fine steel wool does a good job. Snap ring pliers make it alot easier too. It looks like the old ones were turning in the motor hubs every now and then.