12mm X 33m 108ft Heat Tape Heat Resistant Tape Heat Transfer Tape Thermal Tape High Temp Tape High Temperature Tape Heat Tape for Sublimation for Heat Press No Residue 1Roll

i use a {cheap soldering station with a hot air gun](https://a.co/d/06nyEWJJ) and [a pcb holder](https://a.co/d/00YppHhP) (to hold the board while you work), [Kapton tape](https://a.co/d/0hUyz0qi) to cover EVERYTHING around the pads you dont want melted, add some [flux](https://a.co/d/08CmaIqt) and more solder to to the joints holding the stick they make it melt faster/easierin 1 hand between 380°C and 450°C (715°F–840°F) with an airflow of 3 to 4 blow on the joints with the heat gun in the other grab the stick and gently pull down on the stick with some pliers so once the solder melts you can pull it free now do the opposite with the new (preferably TMR) stick and once its in add more solder until its a smooth cone on top and you're good an if you use TMR sticks use this site to calibrate them and youre goodhttps://dualshock-tools.github.io/ its kinda expensive upfront but it will be worth it in the long run and if thats too much you can try to find a local shop that will do repairs and supply them with the sticks and have them do it i had none within 100m so i just bit the bullet