6 Pcs Precision Tweezers Set, Premium Anti-Static Stainless Steel Tweezer, ESD Curved of Tweezers for Electronics, Craft, Laboratory Work, Jewelry-Making, etc

I use a slow setting CA glue from VMS along with a CA glue debonder and a CA glue accelerator. These three products form a system to accurately place PE parts, have enough time to get them into the right position, then clean up the excess and lock them in. My workflow is this: Pool a pea sized drop of CA glue onto a disposable surface (I use a jar lid). Cut out part from PE fret. Use diamond file to remove attachment nub. Bend (if required). Check part fit/alignment. Dip CA glue applicator into CA glue. I use a length of copper wire with the end smashed flat. This is attached to an old brush handle. Apply glue to intended surface one small dab at a time. Pick up part with tweezers or silicon tool. I like these tweezers and this silicon grabber tool. Place part onto model. Nudge into place. Wait about 30 seconds to 1 minute,. Apply debonder with a small brush. I like the one from VMS, but any will do. Once satisfied with the placement, use a pipette to apply a drop of accelerator to instantly cure CA. I've used the BSI accelator for years with no complaints. Has a nice smell to it, too. Sort of like rose water.