BTF-LIGHTING FCOB USB Powered Warm White 2700K COB LED Strip Lights 3.28FT 320LEDs 5V 8mm Width 90+ High CRI Ultra Bright Flexible Light for 3D Printer TV Backlight Display Cabinet PC DIY Decor

Sure thing. Super easy, really. I bought a 3.28ft section of these BTF-LIGHTING 5v FCOB LEDs in 2700K color temp and a pack of JST PH 4-pin Pre-Wired connectors (you really only need one.) I just held the strip up to the installation spot with its pre-wired end to my right (the steam-wand side of the machine) and found the approximate length to cut to, then cut the strip at the nearest cut line. I pulled the pins out of the JST connector (easy to do with a utility knife, just raising the plastic tabs) and re-configured it with the black and red wires in the right positions for the 5v supply pins from the Gaggimate Pro board (found in the wiring and board diagrams.) I removed the LED strip’s USB connector and crimped the wires from the JST connector to the LED strip’s wires, ran the strip down through the front bottom corner gap in the Gaggia’s case and installed the strip with its adhesive just on the front of the bottom surface of the machine, in line with the front lip of the water tank. You’ll have plenty of wire to reach your controller wherever you’ve placed it in the machine. Edit: dang, sorry, this was a response to u/OK-Break5074 asking how I installed this, but it didn’t nest properly under their comment.