100Pcs Tactile Push Button Switch, SMD DIP 2 Pin Micro Momentary Tact Switch, 3mm x 6mm x 2.5mm for Phone GPS MP3 MP4 DIY Electronic

https://www.youtube.com/watch?v=TVKwpLu8_JU&list=LL&index=4 The video I followed, parts are listed in its description. Parts I used were: for the switch since it lets me control two signals instead of one, (therefore one switch is needed not two) https://www.amazon.com/dp/B07F7PNDGM? The button I used was this one since its narrow long profile fits the laynard hole and is thin enough to sit next to the switch. https://www.amazon.com/dp/B08FX3WZV1? Here is the bracket I designed to go in place of the lanyard bracket. https://drive.google.com/file/d/1ib8zX32RBj6_6pfgnYjOBZqP1siIZqlS/view?usp=sharing The only big difference you will notice from the video tutorial is that the headphone jack's ground signal that tells the pixel2 which audio output to use (speaker vs headphones) is backwards to the miyoo mini +. So you have to unsolder the top right headphone jack pin from its pad, isolate the pad with some tape, and solder a wire from the pad/ pin to the switch. Essentially, BT board power on? Disconnect ground signal to headphone jack and the speaker will turn off. Use the 3rd row of pins on your switch to achieve this.